PlusPutt Instruction Manual
Quick start
- Clip stand shaft into base until it locks
- Clip device into top of stand
- Switch on to activate cross-line laser
- Align vertical beam with start line, horizontal beam with face
- Stance, alignment, stroke
PlusPutt overview
- Green cross-line laser for start line and face angle
- For putting mats, indoor greens, and outdoor practice
- USB-C rechargeable (cable not included)
Included components
- PlusPutt device
- Two-piece stand (base + shaft)
- USB-C charging port (cable not included)
- Optional: shaft mount, gate, travel case
Assembly and setup
Stand
- Insert shaft into base until click
- Clip device into top
- Rotate device to level horizontal beam
Shaft mount (if included)
- Snap onto putter shaft
- Clip device
- Align vertical beam with target line
Putting gate (if included)
- Place in front of ball
- Start wider, narrow as accuracy improves
Using the laser
- Vertical beam for start line
- Horizontal beam for face and eyes
- Ball should start down beam
- If not, alignment or stroke path issue
Laser shows true start direction
Charging and battery
- USB-C cable not included
- Charge indicator light
- Red = charging
- Blue = fully charged
- Unplug after 1–2 hours
- Avoid long-term deep drain
Maintenance
- Clean lens with microfiber
- No chemicals or alcohol cleaners
- Keep out of heat (car, sun)
- Store safely when traveling
Troubleshooting
| Issue | Solution |
|---|---|
| Dim laser | Recharge, reduce bright light glare |
| Will not clip | Re-align, press until click |
| Laser angled | Push and lightly twist the gold front of the device to fine tune; very small movements adjust beam angle |
Thank you for choosing PlusPutt. Master your start line. Master your putt.